Barrie Home Inspector

Home Maintenance and Tips for Home Owners

Month: June 2013

Energy Conservation in your Home

Heating, Home Inspection, Real Estate

Energy Conservation in your Home. Turning your home into an energy efficient house not only helps the environment but also saves you up to forty percent in your energy consumption charges. This is in comparison to the average home in North America.

Keep your furnace clean, lubricated and properly adjusted with annual maintenance. If your furnace is working at peak efficiency it will use less energy and cost less to operate. Clean or replace the filter every 1-2 months – a dirty filter reduces the airflow and forces the furnace to run longer to heat your home. Set back your thermostat when nobody is home and at night when everyone is sleeping for added savings. Heating your home constitutes your largest energy expenditure. Even a little conservation of heating fuel goes a long way toward achieving a lower utility bill. Dialing down the thermostat one degree during the winter can result in about 1 to 3 percent less fuel use, and a similar reduction in your heating bill.

When doing laundry use cold water and save from 85 to 90 percent of the energy you would normally use. Front loading machines use less water and energy, up to fifty percent. Also wash full loads to ensure you are fully utilizing energy being consumed.

You can make a lot of progress toward improving the energy efficiency in your home by simply plugging the many places through which air can get in or get out. Plugging your home is called “air sealing,” and it is one of the most important first steps to take when weatherizing your house to increase its energy efficiency.our windows and doors allow a lot of energy to escape which is costing you money. Ensure all your window frames, door frames and sills are caulked using a silicone based sealant. Make sure your heat registers are not being blocked by furniture.

Your water heater is the next largest home energy load after heating and cooling. To reduce water heating energy use ensure your water heater’s thermostat is set to 120F . Improvements such as installing low-flow faucets and shower heads, and insulating hot water pipes will also help you save money on water heating. When replacing your hot water heater consider buying an Energy Star model to ensure greater efficiency.

Air conditioners typically have a life expectancy of twenty years. Even after your unit is 10 years old you can save up to 40 percent of your efficiency by replacing your older model with newer air conditioner with a minimum SEER rating of 15.

Learn about Barrie Home Inspection Information. Stop by The Barrie Home Inspector’s site where you can find out all about the Barrie Home Inspection Services you will need.

Infrared Cameras and Home Inspections

Home Inspection

Infrared Cameras and Home Inspections.  Thermal imaging is the use of light rays that are invisible to the naked eye. There is an infinite range of light that is invisible to the naked eye. The wave lengths of light that are invisible to the naked eye are actually quite small. All light is identified by its wave length, frequency and energy.

Humans can only see light in the 400 to 750 nanometer range. Some animals can see light in the infrared spectrum and you can buy infrared film for you regular camera. An example of low-energy light rays is radio waves which are typically described by their frequency.

A prism placed into a ray of sunshine in a dark room reflects the colours of the rainbow using a property known as dispersion. This is the method Sir William Herschel utilized in the 1800’s in conjunction with thermometers to discern the presence of invisible light rays. He called his discovery the thermometric spectrum later to be known as infrared.

Using a infrared camera is a quick and easy method of determining the presence of air leaks in the exterior walls and ceilings of homes, also known as the building envelope. Although un-able to measure scope of leak it identifies where leaks are present. Infrared cameras are also an excellent means of finding moisture in walls and ceilings and are a valuable tool for professional home inspectors.

The benefits of employing infrared thermography in buildings are; Air leakage pathways present within a completed construction can be identified and rectified prior to subjecting the building to air permeability tests, reducing the risk of repeat testing being required; Depending upon the nature of the construction, even a building that meets or exceeds the building regulations may still be at risk of premature deterioration due to air leakage and subsequent condensation, therefore identifying where air leakage is occurring can be critical; Air leakage pathways can often indicate rainwater ingress pathways further adding to the potential benefits of an infrared survey; and Thermography is commonly used to identify air change rates with the help of the so-called ‘blower-door’ process, which creates under-pressure in buildings. Because the air pressure outside is higher than the pressure inside, the air will try to enter through unsealed areas. Using an infrared camera, this airflow can easily be seen, clearly revealing any unsealed areas, which can then be attended to before coverings and fittings make correcting this potential fault both expensive and time-consuming.

The Barrie Home Inspector was the first company to use Thermal Imaging technology in Simcoe County and now offers the service Free on request for any home inspection package. As a Certified Building Code Official with the Ontario Building Officials Association and with the experience of over 4,000 home inspections your Peace of Mind is 100% Guaranteed.

Want to find out more about Simcoe County Home Inspector, then visit Barrie Home Inspector’s site on how to choose the best Best Qualified Home Inspector for your real estate needs.

Barrie Home Inspector © 2013 Frontier Theme